There are two types of modern tub drain strainers, those with a cross bar and those without a cross bar. The latter of the two has no cross bar to allow a pop-up plunger to be used, much the same way as a lavatory pop-up. These two variations have been used all the way back to the early mid-century. There are a host of tools designed to help in the removal of tub strainers and still it is not uncommon for them to be removed with a saw.
Tub drain strainers before the mid-century going back to the Victorian period can present an entirely different problem. Yes they are as frozen in place as later versions but many times there are no tools for the task of removing them. Many of them are not just old and part of assemblies that are to be restored, they are beautifully ornate as well.
|This beautiful strainer, circa 1900, fared well, coming away from removal nicely intact.|
This is the two part style. The top has a female thread that fits to the male thread of the flange.
It typically requires a propane torch flame to induce them to separate.
This one part strainer was not so lucky.
I was not able to reshape it and it was replaced.
|Here is another two part, I was able to straighten the minor damage to the spokes of the strainer but the drain boot was too mangled by the force required to remove it. I was able to find another.|
Last week I was told that I will be receiving a vintage standing waste for restoration. I have seen this tub and waste and know that the strainer is vulnerable to damage when removed. It may take considerable force to unthread it from the boot below the tub. As it so happens I have a strainer here that is the same size and pattern so I decided to fabricate a removal tool. It will probably take more force than a plastic wrench will tolerate so I needed to make my tool out of steel.
I put a lot of thought into it but didn't decide upon a design until about four days go. I woke early and designed it with my eyes closed and my head on the pillow. Today I finished it, it isn't exactly what I envisioned but it's close.
This is a one part strainer made by "Standard Sanitary" about 1910, before the merger with "American Radiator".
Making my custom tool was a lot of work. I started with a piece of 1/4" steel plate and selected a hole saw that is slightly smaller than the strainer top. With the steel clamped to the drill press table I cut my disc from the plate. Once I had my disc I marked it using the vintage strainer as a template. I drilled my six holes in two steps to help me stay on center, the center hole I had from the hole saw.
The target hole size was to allow 7/18ths" bolts to pass through. The heads had to be removed as the holes are too close to allow them. I selected small brass washers and threaded them to 7/16" x 20 thread per inch. They are the stops that lock the headless bolts on the forward side of the plate. I needed nuts on the other side but again the nuts wouldn't fit that closely together any more that the bolt heads would. 3/8" nuts would fit and I needed tall coupling nuts that would penetrate the ratchet socket I planned to use to turn my tool. I drilled and retapped my coupling nuts from 3/8" x 16 to 7/16" x 20. When it all fit together the nuts made a circle of six, six sided nuts with six outside faces. A center nut bolted through the center hole holds the outside ring true and gives resistance against the force of the socket.
|Note how large the bolts look inside of the formerly 3/8" nuts.|
That is a 3/4" drive socket which will take a seriously large wrench.
This custom tub strainer wrench is ready for work.
Post a Comment
Your comments about this blog are welcome and appreciated.